Alarm.com ADC-SWM150 Smart Water Valve and Meter

is the ACD-SWM150 smart water valve compatible with Vivent security system?

You would have to ask Vivent that question. My understanding is that Vivent is a proprietary system so I would guess it is not. In any case you wouldn't be able to use it without their assistance and they may not allow you to use any 3rd party equipment not purchased from them so you would want to check with them before purchasing for sure.

Does this measure water consumption, time of day etc? If so, how is the data viewed?

Yes, the SWM-150 is able to measure water in increments of 5 gallons, and updates every hour. Through the Alarm.com app or computer portal, you provides a card that shows you the timeline. 

Does this have the ability to sense a battery backup is being depleted and automatically shut off the water before the backup battery is fully depleted?

No, the SWM-150 can only monitor water flow and shut its valve when there is a suspected leak or if you set up an automation rule that follows a time or command. However, if you have an automation device that can monitor a battery, you could likely set up automation rules within Alarm.com that allow you to shut the valve in the event the battery dies and that other device is triggered. 

Is there output capabilities on this device to shut down my constant pressure boost pump which is located after the device once I install it. I can use a normally open or normally closed signal to my pump controller. In the event the device closes the water I do not want my pump to continue to run. The documentation mentions "Note: The blue AUX cable is reserved for future use. It is recommended to leave this cable disconnected." Is this the way to do it?

The blue wire still has yet to have a specific purpose, but we suspect that will be its use at some point when the day comes. For now, in this case, I think your best bet is to use another Z-wave relay device, and when the shutoff rule for the SWM shuts the valve, use another automation rule to close/open the relay so it shuts down your pump as well. 

Do you publish Pressure Drop/Flow Data across the valve?

Alarm.com does not show pressure or precise flow readings from the meters, but it does show consumption in gallons. It monitors the flow rate to watch the averages and alert you if something is off, but you cannot visually see the metrics it watches. 

Will this allow irrigation bypass for sprinklers?

Yes, the first few days of operation, the SWM150 only watches your water consumption to figure out what your typical usage looks like. If your sprinkler system is on a set timed pattern the unit will learn that during those times a lot of water will be used. However, if you change the timing of the sprinklers kicking on though you might need to recsync the unit.

What are the compatible with water sensors that can be paired to automatically shut of the main water supply if that sensor is tripped?

When using this device, any flood sensor can be used as long as your alarm system is connected to Alarm.com service. The sensors do not pair with the water valve, but rather with the system, and the Alarm.com automation options are what trigger the valve to shut off.

How come I can shut off this valve manually and through the water sensors, but not on my app?

You can shut it off via the app if you have an alarm.com plan that includes automation.

Can it be installed vertically or horizontal?

Yes it can. Orientation does not affect the functioning of this product.

Is it using the home wifi or zwave via cellular

It communicates via Zwave to a compatible alarm system.

Where can I get this in canada

We ship to Canada. I've no idea where you could buy it locally though.